inverted rear shock? - Moparts Forums

Register Log In Moparts Forums Unlawfl's Race & Engine Tech inverted rear shock?

Print Thread

Page 2 of 2

1

2

Re: inverted rear shock? [Re: Clanton] #1836077 05/28/15 04:49 PM 05/28/15 04:49 PM
Joined: Nov 2004 Posts: 6,890 North Alabama M Monte_Smith master
Monte_Smith master M Joined: Nov 2004 Posts: 6,890 North Alabama	Their JOB is to stop housing roll...........so crank on them some more Monte

Re: inverted rear shock? [Re: Clanton] #1836079 05/28/15 04:50 PM 05/28/15 04:50 PM
Joined: May 2011 Posts: 4,489 northern,Ohio,USA C Clanton OP master
Clanton OP master C Joined: May 2011 Posts: 4,489 northern,Ohio,USA	I called Caltrack and they said to put 1/4 turn pre load in both sides but is this enough? GOTBOOST!New improved with Victor heads. http://www.enginelabs.com/mopar-big-bloc...t-of-necessity/

Re: inverted rear shock? [Re: Clanton] #1836124 05/28/15 06:12 PM 05/28/15 06:12 PM
Joined: Dec 2003 Posts: 22,772 Bitopia J jcc If you can't dazzle em with diamonds..
jcc If you can't dazzle em with diamonds.. J Joined: Dec 2003 Posts: 22,772 Bitopia	Reality check, that half the population is smarter then 50% of the people and it's a constantly contested fact.

Re: inverted rear shock? [Re: Clanton] #1836131 05/28/15 06:43 PM 05/28/15 06:43 PM
Joined: May 2011 Posts: 4,489 northern,Ohio,USA C Clanton OP master
Clanton OP master C Joined: May 2011 Posts: 4,489 northern,Ohio,USA	The Rancho was about 1/2" away from axle tube and there is no bind when I cycle it so it is still good but now I have the new ones on.The brake pads do slide out the top but to take the rotor off a hose may help on stress on the tube.Thanks Dave for pointing that out tho. GOTBOOST!New improved with Victor heads. http://www.enginelabs.com/mopar-big-bloc...t-of-necessity/

Re: inverted rear shock? [Re: Clanton] #1836169 05/28/15 07:35 PM 05/28/15 07:35 PM
Joined: May 2011 Posts: 4,489 northern,Ohio,USA C Clanton OP master
Clanton OP master C Joined: May 2011 Posts: 4,489 northern,Ohio,USA	The damage on the tube is 7 1/2" from the lower shock eyelet and the o/c to the axle/eyelet is about 5 1/2" at rest.The shock is at a 45* so ^ makes sense.I am rambling I know.:) Last edited by Clanton; 05/28/15 07:59 PM. GOTBOOST!New improved with Victor heads. http://www.enginelabs.com/mopar-big-bloc...t-of-necessity/

Page 2 of 2

1

2

Moderated by Al_Alguire, Hotwheelsjr, moparts, not_a_charger, RangerDan440, tboomer

Hop To

Powered by UBB.threads™ PHP Forum Software 7.7.1