new cuda brake prop valve leaks bad! - Moparts Forums

Register Log In Moparts Forums Moparts Question and Answer new cuda brake prop valve leaks bad!

Print Thread

new cuda brake prop valve leaks bad! #1165642 01/26/12 08:28 PM 01/26/12 08:28 PM
Joined: Aug 2006 Posts: 1,351 warfordsburg, PA dirt OP pro stock
dirt OP pro stock Joined: Aug 2006 Posts: 1,351 warfordsburg, PA	i just pulled the cuda out of the garage and almost didnt have any brakes. the new brake prop valve was leaking around the nut on the bottom and the nut where the wire harness hooks on. any idea if this could be an easy fix? i tried calling the place where i got it but its too late today i guess. i had some one pump the brakes while i watched to be sure that is where it comes from and it is. it emptied the mastercylinder in about 200' of driving

Re: new cuda brake prop valve leaks bad! [Re: dirt] #1165643 01/26/12 08:42 PM 01/26/12 08:42 PM
Joined: Nov 2003 Posts: 36,041 Lincoln Nebraska R RapidRobert Circle Track
RapidRobert Circle Track R Joined: Nov 2003 Posts: 36,041 Lincoln Nebraska	I'd see if the fitting is tight & if so then unscrew it & go inside & good visual/check the seal/washer that it uses. No exp w them but that's where I'd start EDIT It's the brass block not the brake line inverted flare fitting/line itself right? If #2 I'd reflare the line Last edited by RapidRobert; 01/26/12 09:08 PM. live every 24 hour block of time like it's your last day on earth

Re: new cuda brake prop valve leaks bad! [Re: dirt] #1165644 01/26/12 09:38 PM 01/26/12 09:38 PM
Joined: Nov 2005 Posts: 323 MERRILLVILLE, INDIANA S sunroof446 enthusiast
sunroof446 enthusiast S Joined: Nov 2005 Posts: 323 MERRILLVILLE, INDIANA	Quote: i just pulled the cuda out of the garage and almost didnt have any brakes. the new brake prop valve was leaking around the nut on the bottom and the nut where the wire harness hooks on. any idea if this could be an easy fix? i tried calling the place where i got it but its too late today i guess. i had some one pump the brakes while i watched to be sure that is where it comes from and it is. it emptied the mastercylinder in about 200' of driving I had the same problem with a cuda I put together. They never tightend it from the place that made them. Just tighten it up. You should be ok.

Moderated by Al_Alguire, Hotwheelsjr, moparts, not_a_charger, RangerDan440, tboomer

Hop To

Powered by UBB.threads™ PHP Forum Software 7.7.1