Drag Radials...Are you putting screws in them??? - Moparts Forums

Register Log In Moparts Forums Unlawfl's Race & Engine Tech Drag Radials...Are you putting screws in them???

Print Thread

Page 2 of 2

1

2

Re: Drag Radials...Are you putting screws in them??? [Re: Ari440] #1013903 06/15/11 11:48 PM 06/15/11 11:48 PM
Joined: Oct 2007 Posts: 1,070 Big Western Pencilveinya U Uncle Barry super stock
Uncle Barry super stock U Joined: Oct 2007 Posts: 1,070 Big Western Pencilveinya	Quote: I have bougth a set of 295 65 15 and mounted them on a 8 inch rim is this good or would a 10 inch rim be better 8 inch rim will be just fine. thats what i run too

Re: Drag Radials...Are you putting screws in them??? [Re: Uncle Barry] #1013904 06/15/11 11:50 PM 06/15/11 11:50 PM
Joined: Jan 2003 Posts: 1,633 Jacksonville, NC RonP top fuel
RonP top fuel Joined: Jan 2003 Posts: 1,633 Jacksonville, NC	Screws on all 6 sets I have been through, but my wheels had holes already. Probably would have anyway. best of 1.29 60 and 100's of 1.30-1.31's.

Re: Drag Radials...Are you putting screws in them??? [Re: RonP] #1013905 06/16/11 09:35 AM 06/16/11 09:35 AM
Joined: Jan 2003 Posts: 13,404 Marion, South Carolina [><] an8sec70cuda I Live Here
an8sec70cuda I Live Here Joined: Jan 2003 Posts: 13,404 Marion, South Carolina [><]	I'm in the same boat as RonP. Mine are screwed (no tubes) but my rims were already drilled for screws. I run 295-65 radials on 8.5" wide rims. Mid 9s, 1.32 sixty foot at 3800#. I've never heard of anyone rumnning tubes in drag radials until I read this thread. I don't see the point, but hey, if it works... CHIP '70 hemicuda, 575" Hemi, 727, Dana 60 '69 road runner, 440-6, 18 spline 4 speed, Dana 60 '71 Demon, 340, low gear 904, 8.75 '73 Chrysler New Yorker, 440, 727, 8.75 '90 Chevy 454SS Silverado, 476" BBC, TH400, 14 bolt '06 GMC 2500HD LBZ Duramax

Page 2 of 2

1

2

Moderated by Al_Alguire, Hotwheelsjr, moparts, not_a_charger, RangerDan440, tboomer

Hop To

Powered by UBB.threads™ PHP Forum Software 7.7.1