Initial/Total Timing - Moparts Forums

Register Log In Moparts Forums Moparts Question and Answer Initial/Total Timing

Print Thread

Re: Initial/Total Timing [Re: RapidRobert] #900091 01/09/11 01:57 PM 01/09/11 01:57 PM
Joined: Jun 2008 Posts: 251 Lithonia, Ga 3 36PLYM OP enthusiast
36PLYM OP enthusiast 3 Joined: Jun 2008 Posts: 251 Lithonia, Ga	I know this has been discussed a lot before but just for clarification- for total timing 1)Disconnect and plug vacuum advance 2)RPMs up to 3000 3)Timing gun set at 35 4)Timing mark on balancer should be at 0 36 Plymouth Coupe 318 w/360 heads 518 trans 8 3/4 rear Ga. Tech BCE'78

Entire Thread
Subject	Posted By	Posted
Initial/Total Timing	36PLYM	01/09/11 02:29 PM
Re: Initial/Total Timing	buildanother	01/09/11 02:36 PM
Re: Initial/Total Timing	RapidRobert	01/09/11 02:39 PM
Re: Initial/Total Timing	36PLYM	01/09/11 05:57 PM
Re: Initial/Total Timing	MoparforLife	01/09/11 06:14 PM
Re: Initial/Total Timing	RapidRobert	01/09/11 06:15 PM
Re: Initial/Total Timing	36PLYM	01/09/11 06:21 PM
Re: Initial/Total Timing	quickd100	01/09/11 06:54 PM
Re: Initial/Total Timing	36PLYM	01/09/11 10:43 PM
Re: Initial/Total Timing	roe	02/06/11 09:37 AM
Re: Initial/Total Timing	six-barrel	02/07/11 03:52 AM
Re: Initial/Total Timing	RapidRobert	02/07/11 05:32 AM
Re: Initial/Total Timing	Sinitro	01/09/11 10:52 PM
Re: Initial/Total Timing	Plum440	01/09/11 10:55 PM
Re: Initial/Total Timing	36PLYM	01/09/11 11:06 PM
Re: Initial/Total Timing	RapidRobert	01/09/11 11:47 PM

Moderated by Al_Alguire, Hotwheelsjr, moparts, not_a_charger, RangerDan440, tboomer

Hop To

Powered by UBB.threads™ PHP Forum Software 7.7.1