Anyone running this cam, particulalry in a mild stroker?

Part #23-712-9
286/294, 236/242 at 0.050"
0.363"/0.361" at the lobe

Just debating between going this route or going with a mechanical flat tappet...something about that just seems right?! I have to investigate my options though, so...

I'd probably be looking at this roller or something along these lines, maybe a tad smaller (280 for example).

I'm interested in performance (power, et, etc), streetability, and your overall satisfaction with the cam.

In my fictitious scenario we are talking about a 493-500" RB, good flowing Eddy heads, and components to match the cam. I have the crank, rods, and heads ready to go...the cam and pistons will be matched once something is selected.

Let me know if you have this cam, had this cam, or have any direct first-hand knowledge of how it performed in a similar set-up.

Thanks in advance!