I was laying under the convert looking at the unibody. I already tied the frame rails, If I extend the tie in past the trans cross member & tie it into the front rail would it help to strengthen the front by triangulating that area ? I think the front rails were angled in that area to clear the torsion bars & I'm going with something different. I also still have the trunk floor out. Will it help any to try to straighten the rear rails ( Going triangulated 4 link). I don't want to reinvent the wheel, But while it's all apart now would be the time to give it all the strength I can short of a tube frame ( but don't mind adding extra tubes )