Glazing high gear clutches on the street?

Print Thread

Re: Glazing high gear clutches on the street? [Re: dennismopar73] #687999 05/04/10 08:46 PM 05/04/10 08:46 PM
Joined: Aug 2005 Posts: 762 Southington Ct. T turbobitt super stock
turbobitt super stock T Joined: Aug 2005 Posts: 762 Southington Ct.	Quote: never liked tci junk i have hade several buddy had acomplete trans /convert from them bolt in with fluid burned up in less than 300 miles and jegs didnt warrenty it because it went into a 'race car' but i agree with the above line pressure, or miss adj bands I just rebuilt a TCI(Total Crap Inside) and found a mismatch of parts. This transmission had badly worn front and rear cluches and a stuck PR valve. The pump was a late model with wide bearing journal and the drum was an early type with narrow bearing. Allan G. 1970 Challenger w/572 Hemi street car and my pride and joy. 1986 T-Type with 272 Stage 2 Buick V6 engine - True 8 second street car. Just updated the engine and put down 928 HP @ 35# boost to the ground on chasis dyno. 1976 Cee Bee Avenger Jet Boat - 460 Ford powered.

Entire Thread
Subject	Posted By	Posted
Glazing high gear clutches on the street?	whiplash	05/04/10 02:10 PM
Re: Glazing high gear clutches on the street?	maximum entropy	05/04/10 03:25 PM
Re: Glazing high gear clutches on the street?	Dragula	05/04/10 04:41 PM
Re: Glazing high gear clutches on the street?	whiplash	05/04/10 05:21 PM
Re: Glazing high gear clutches on the street?	JohnRR	05/04/10 05:43 PM
Re: Glazing high gear clutches on the street?	Dragula	05/04/10 06:20 PM
Re: Glazing high gear clutches on the street?	dOc …	05/04/10 06:25 PM
Re: Glazing high gear clutches on the street?	John_Kunkel	05/04/10 09:39 PM
Re: Glazing high gear clutches on the street?	dennismopar73	05/04/10 11:55 PM
Re: Glazing high gear clutches on the street?	turbobitt	05/05/10 12:46 AM
Re: Glazing high gear clutches on the street?	whiplash	05/05/10 05:39 PM
Re: Glazing high gear clutches on the street?	MR_P_BODY	05/04/10 06:35 PM

Hop To