OK - so I have much of the stuff figured out. Fronts - You need to intall the slider bracket near the rear of the door first and then the regulator. Then the front and rear slides some of which are marked left and right if you look closely. I am still needing to get the pieces that bolt the long bracket to the window itself from R/T Specialties so the windows aren't in,but well on their way.

Rear - firgured it was much the same so I put the regulator in first since the piece the square slider goes into was already in the door. The square plastic slider goes into the middle of the slide bracked and the round roller goes on the outside. I still need to polish the stainless piece that goes in front of the window on both sides, so I am at kind of a standstill there.

For any of you dreading the process the worst part is probably cleaning the old grease and grime off of the rollers and brackets. Good Luck to you all!