Milling Edelbrock heads? - Moparts Forums

Register Log In Moparts Forums Unlawfl's Race & Engine Tech Milling Edelbrock heads?

Print Thread

Re: Milling Edelbrock heads? [Re: Y3 70 BEE] #639241 03/13/10 10:25 PM 03/13/10 10:25 PM
Joined: Dec 2007 Posts: 10,542 BROOK PARK, OH WILD BILL Senior Member of the Junior Dragster Club
WILD BILL Senior Member of the Junior Dragster Club Joined: Dec 2007 Posts: 10,542 BROOK PARK, OH	How far in the hole are the pistons? I ran a 555 solid lift cam W/ OOTB eddy heads and flat top pistons (no releifs) that were .102 in the hole with no contact.

Entire Thread
Subject	Posted By	Posted
Milling Edelbrock heads?	Y3 70 BEE	03/14/10 01:40 AM
Re: Milling Edelbrock heads?	WILD BILL	03/14/10 01:49 AM
Re: Milling Edelbrock heads?	n_bogie1984	03/14/10 01:53 AM
Re: Milling Edelbrock heads?	Y3 70 BEE	03/14/10 02:17 AM
Re: Milling Edelbrock heads?	WILD BILL	03/14/10 02:25 AM
Re: Milling Edelbrock heads?	Y3 70 BEE	03/14/10 03:23 AM
Re: Milling Edelbrock heads?	WILD BILL	03/14/10 03:36 AM

Moderated by Al_Alguire, Hotwheelsjr, moparts, not_a_charger, RangerDan440, tboomer

Hop To

Powered by UBB.threads™ PHP Forum Software 7.7.1