Need advice on milling heads on a '73 440.

Print Thread

Re: Need advice on milling heads on a '73 440. [Re: timinator] #570895 01/03/10 02:42 PM 01/03/10 02:42 PM
Joined: Dec 2007 Posts: 85 central illinois 6 65dodgebob member
65dodgebob member 6 Joined: Dec 2007 Posts: 85 central illinois	the formula for head milling is to remove .0125 off the intake face for every .010 removed from head surface. i think that spec came from dick landy. but i would also think about new pistons.

Entire Thread
Subject	Posted By	Posted
Need advice on milling heads on a '73 440.	timinator	01/03/10 05:47 PM
Re: Need advice on milling heads on a '73 440.	74fldart	01/03/10 06:06 PM
Re: Need advice on milling heads on a '73 440.	DaytonaTurbo	01/03/10 06:13 PM
Re: Need advice on milling heads on a '73 440.	scratchnfotraction	01/03/10 06:17 PM
Re: Need advice on milling heads on a '73 440.	NachoRT74	01/03/10 06:21 PM
Re: Need advice on milling heads on a '73 440.	Magnum	01/03/10 06:32 PM
Re: Need advice on milling heads on a '73 440.	DaytonaTurbo	01/03/10 06:15 PM
Re: Need advice on milling heads on a '73 440.	65dodgebob	01/03/10 06:42 PM
Re: Need advice on milling heads on a '73 440.	NachoRT74	01/03/10 06:52 PM
Re: Need advice on milling heads on a '73 440.	timinator	01/03/10 06:55 PM
Re: Need advice on milling heads on a '73 440.	NachoRT74	01/03/10 07:09 PM
Re: Need advice on milling heads on a '73 440.	@#$%&*!	01/03/10 07:53 PM
Re: Need advice on milling heads on a '73 440.	JohnRR	01/03/10 07:58 PM
Re: Need advice on milling heads on a '73 440.	RapidRobert	01/03/10 08:22 PM
Re: Need advice on milling heads on a '73 440.	timinator	01/03/10 08:38 PM
Re: Need advice on milling heads on a '73 440.	RapidRobert	01/03/10 08:41 PM
Re: Need advice on milling heads on a '73 440.	DaytonaTurbo	01/03/10 09:26 PM
Re: Need advice on milling heads on a '73 440.	65dodgebob	01/03/10 06:59 PM
Re: Need advice on milling heads on a '73 440.	Dodgem	01/03/10 07:15 PM
Re: Need advice on milling heads on a '73 440.	CrAzYMoPaRGuY	01/04/10 02:21 AM

Hop To