Quote:

Ok, here's my delimma, the floor pan was cut out from in front of the front seat to fire wall. From under the front seat back is really solid with the exception of the sides there is some rot. I'm putting in a set of low back bucket seats w/power seat frames since I don't have the original bench seat. Now the floor under where the front seat is humped up in the middle. I need to make up a riser to bolt my power seat tracks to because they are not high enough. Do you guy's have any suggestions? I hate to cut out the good metal to put a flat floor in so the buckets are level. Thanks, later shawn





early mopar mini vans used a metal base/pedestal to mount bucket seats to, to make them high enough. ide guess late 1980s,,,and most of them on the passenger side had a locking drawer,,if your roof isnt chopped these may work for you,,i grabbed a set a few years ago at a U pull it for 10 bucks,,when i get to the bucket seat part of my 40 ill see if they become of some use,,


1966 barracuda prostreeter super charged 340(SOLD)
1940 dodge coupe 241 hemi street rod
2014 ram express hemi 4x4 dailey driver
2015 cherokee
2013 R/T classic