Quote:

Bump


EDIt: Just reread your post The info given may be useless to you except for the last part.

Flex Plate should have two bolt holes in each ear for both bolt patterns so you should be ok there . When you placed the T/C up to the plate did you do this on a bench or just try to hold the t/c up to the crank? When checking bolt pattern alignment make sure the flex plate is facing the correct direction and its easier to do on a bench.

Oh and if you have any doubts about your trans setup mine is in the classifieds. 727 w/gear vendors it came out of the same basic setup so i know it works

Last edited by OSO; 12/03/09 12:22 PM.