Quote:

Quote:

What do you guys use for an engine limiter (for/aft movement) in these A-bodies when you put in a motor plate ??



...or if you use a 3/8" think plate, is a limiter just not needed ???

(sorry for hijacking this post)
thanks guys!



3/8" plate helps, but plate is not very strong in that direction (thin cros section). You still need a limiter. I only have one and it comes from a bracket that I made to attach to the original motor mount locations on the block down to a clevis bracket welded to the k-frame. I don't have pic's on my work computer to share. Good luck.