I am looking to see if any of the companies out there will rebuild roller lifters. I have run the Comp Endure X 829-16 roller lifters in my stuff for a long time. Have never had an issue. For years I had two sets on rotation. I would remove them after 300 - 350 runs and then replace them. Once I took them out I would send them back to Comp and they would go through them. So I always had a relatively fresh set in the motor with a rebuilt set on hand.

However, Comp is no longer offering this service and it is difficult to find other lifters that have the same cup height. I could replace them but then I am buying new push rods again.

If anyone knows of a place I have three sets that I would send back at this point.

Thanks in advance.