I put enough work into these that will end up thrown into the corner with a pile of other heads. I thought these went 240 with a 1.88 cut into them. Actually it was 204, so I tried to save face a little. 230 and I'm done lol. I put 2.02's into some 360 heads (974's) and got 250 with less work than these. What did your 360's go?
Take a look at this separate thread I had going on the subject of the work I did =>
HEREIn summary:
1) I started with:
LIFT I E
0.100 67 57
0.150 99 79
0.200 130 104
0.250 162 125
0.300 189 140
0.350 215 152
0.400 235 160
0.450 253 167
0.500 262 172
0.550 261 175
0.600 248 177
2) I ended up with:
LIFT - BEFORE - AFTER - %CHANGE
0.100 - 67 - 67 - 0
0.150 - 99 - 102 - 3
0.200 - 130 - 138 - 6
0.250 - 162 - 175 - 8
0.300 - 189 - 205 - 8
0.350 - 215 - 232 - 8
0.400 - 235 - 253 - 7
0.450 - 253 - 267 - 6
0.500 - 262 - 282 - 8
0.550 - 261 - 291 - 12
0.600 - 248 - 283 - 14
It was a great experience doign that work, I will be starting my W2 fairly soon next.
