OK did some more reading on this myself and know the direction I'm headed but to fill in the blanks:

MSD 6A,
MSD Blaster2 coil,
MSD spiral core wires.

The distributor itself is an MP electronic.

Reading my paperwork a few times I see it says no Ballast is needed (makes sense) but it also said you can leave the stock ballast. Reading about the coil it stated no Ballast needed so I guess they are saying if you are using all of our system remove ballast for our coil to work properly but you can also run this system with a stock coil and then the ballast can stay.

This was an existing set-up put in by previous owner so I would have thought any problems would have arisen already with this Ballast in place.
I am going to bypass it and test from there.

Thanks Ron