If it's a real track car, then check out DOT5.1 fluid. We use Motul brand in our endurance racing track car. Basically, the higher the number, the higher the boiling point. DOT is silicone based, but DOT5.1 is the same chemical type as DOT3 and 4, so you can mix them if you wish.
This a drag race car that will be ran at our local 1/8 mile track to see if the owner likes drag racing or not. It might run 120.+ MPH in the 1/8, we will see
I do not know anything about that motor, I may offer to make 1 or 2 passes in the car to make sure it goes straight and stops before advising him to go WOT in it
I will suggest that he tries a couple of part throttle launches and lifting at half track and go from there. If he likes it and wants to go for it I'll advise him to foot brake launching it at different RPM before switching to trans brake launching it later at WOT
