I had posted in the truck section about my quest for a new cam for towing, on my 96 5.9L gas motor. I had a head issue was addressing a burnt valve issue and figured why not. I have a UTA cam on order and while I was waiting,dug deeper to get the old cam out.
Very bad day after pulling the cam. Found two bearings that are shot. Cant say I have ever seen this sort of wear, but I did find others with similar.
I have never done came bearing work, but up to the challenge. I cant figure out how to get them out in vehicle though. I am assuming the rear bearing cant be done without engine removal but the others maybe can be?