I have a chassisworks eliminator II 4 link that i am getting close to install on a backhalf car. Before welding it in place, i layed everything out on the floor and set everything up at the instructed measurments. I noticed that the arc of holes on the frame bracket (upper set of holes and lower set of holes) only line up in a perfect arc with 1 lower and 1 upper hole of the axle bracket. The other axle adjustment holes upper set and lower set throw off the arc on the frame bracket that i would have to adjust the length of the links to travel through those arcs. I hope i’m making sense with how i’m explaining this. Is this normal? I am thinking it is because lifting or lowering the pivot point at the axle would change the arc at the frame bracket. Just want to make sure this is what you experience also before i install.

Thx