Head Chamber Size and Compression Ratio

Print Thread

Re: Head Chamber Size and Compression Ratio [Re: hp383] #2817139 09/04/20 09:30 PM 09/04/20 09:30 PM
Joined: May 2008 Posts: 171 Las Vegas, NV C chargerbr549 member
chargerbr549 member C Joined: May 2008 Posts: 171 Las Vegas, NV	What you could do is get a set of 75 cc E street heads mill them around .025" and use the factory steel shim head gasket and get just a little over 9 to 1 compression ratio, that way you can leave the pistons alone if the bore looks good.

Entire Thread
Subject	Posted By	Posted
Head Chamber Size and Compression Ratio	hp383	09/04/20 10:18 PM
Re: Head Chamber Size and Compression Ratio	CSK	09/04/20 11:54 PM
Re: Head Chamber Size and Compression Ratio	fast68plymouth	09/05/20 12:08 AM
Re: Head Chamber Size and Compression Ratio	hp383	09/05/20 12:59 AM
Re: Head Chamber Size and Compression Ratio	chargerbr549	09/05/20 01:30 AM
Re: Head Chamber Size and Compression Ratio	polyspheric	09/05/20 12:25 AM
Re: Head Chamber Size and Compression Ratio	BSB67	09/05/20 12:35 AM
Re: Head Chamber Size and Compression Ratio	calrobb2000	09/05/20 02:29 AM
Re: Head Chamber Size and Compression Ratio	polyspheric	09/05/20 03:21 AM
Re: Head Chamber Size and Compression Ratio	hp383	09/05/20 07:18 AM
Re: Head Chamber Size and Compression Ratio	Cab_Burge	09/05/20 12:46 PM
Re: Head Chamber Size and Compression Ratio	BSB67	09/06/20 11:31 AM
Re: Head Chamber Size and Compression Ratio	gzig5	09/06/20 03:04 PM
Re: Head Chamber Size and Compression Ratio	polyspheric	09/06/20 03:14 PM
Re: Head Chamber Size and Compression Ratio	gregsdart	09/07/20 02:53 PM

Hop To