STOP!!!!
What a bunch of cave men, just like the other crappy advice most get these days
The real problem is the z bar bearing retainer is not in the center groove of the bearing as it should
Ask sogtx about that one....
ok back to my cave
“What a bunch of cavemen” that’s pretty funny.
I’ll have to check that. If retainer ends are on the outermost edge of the bearing the zbar would be pushed more toward the bell housing causing the arm to be mis-aligned enough to where the bent rod wouldn’t work. Am I understanding what you mean?
You may be on to something. I’ll have to check tomorrow.
