Ring clearance in piston - Moparts Forums

Register Log In Moparts Forums Unlawfl's Race & Engine Tech Ring clearance in piston

Print Thread

Re: Ring clearance in piston [Re: cudaman1969] #2737683 01/29/20 12:31 PM 01/29/20 12:31 PM
Joined: Jan 2003 Posts: 15,439 Val-haul-ass... eventually B BradH Taking time off to work on my car
BradH Taking time off to work on my car B Joined: Jan 2003 Posts: 15,439 Val-haul-ass... eventually	IIRC, .001 to .002" falls in the "acceptable" range. Not supposed to be any tighter, though. I checked the clearance on my last rebuild w/ some Total Seal rings and they were close to .002"; had a set of Mahle on hand that tightened that up about .0005", so I used the Mahles.

Entire Thread
Subject	Posted By	Posted
Ring clearance in piston	cudaman1969	01/29/20 04:02 PM
Re: Ring clearance in piston	BradH	01/29/20 04:31 PM
Re: Ring clearance in piston	Cab_Burge	01/29/20 06:05 PM
Re: Ring clearance in piston	dOoC	01/29/20 06:22 PM
Re: Ring clearance in piston	cudaman1969	01/29/20 07:09 PM
Re: Ring clearance in piston	wyoming	01/30/20 07:03 AM
Re: Ring clearance in piston	cudaman1969	01/30/20 03:35 PM
Re: Ring clearance in piston	BradH	01/30/20 03:52 PM
Re: Ring clearance in piston	cudaman1969	01/30/20 04:29 PM
Re: Ring clearance in piston	Cab_Burge	01/30/20 02:25 AM
Re: Ring clearance in piston	LSP	02/09/20 04:34 PM
Re: Ring clearance in piston	cudaman1969	02/09/20 06:45 PM

Moderated by Al_Alguire, Hotwheelsjr, moparts, not_a_charger, RangerDan440, tboomer

Hop To

Powered by UBB.threads™ PHP Forum Software 7.7.1