That is one of the fasteners that need to be installed and torque before installing the motor
Uhhh, nah. Not dropping the k-frame to install it. Not pulling the engine to install it, then fighting to get the bracket on the engine. Its the nut on the RIGHT. Pic is rotated.
Flare nut wrench is 6pt, thus 60deg angle to gain any tightening. I don't have 60deg swing there. Not sure if I can get 30deg. I think I'll further flatten a12pt box wrench, and if it doesn't fit, I'll relook at pulling the oilpump. If either works, I'll post a new photo. A big thanks for the suggestions. Maybe it'll run this weekend.
