Todd and dvw,
OK
I went and looked.
I for sure have the CB481P 020 but not the H series. Ironically I do have some CB481H in a .30 under...
Todd
Thank you for looking into this. Since I already have the CB481P bearings coming my way it makes no sense to get another set. You are right, the 0.030" is ironic sizing, and to do that I would have to re-gring the crank at which point in time I really should aim for the 2.100" journal size instead and open up the selection to a massive list of bearings.
Gentlemen, thank you again, I appreciate your help but I will pass up on the opportunity at this point in time.
