Measured mine, measurements are to the nameplates & birds once installed, but you should be able to work backwards to get locations for mounting holes.
Door emblems - 3 3/8" from ft door edge to edge of nameplate, also 3 3/8" from top of door contour to top of nameplate.
Door birds - 2 1/2" from top door contour to top of bird, bird is about centered vs nameplate, 1/4" from rear of nameplate to bird. Birds are running toward front of car.
Trunklid - RR nameplate 1/4" above middle contour of lid to bottom of nameplate, 2 1/4" from rt edge of lid to rt edge of nameplate.
Trunk bird is standing, not running, centered above RR nameplate with a 3/8" gap.
"Plymouth" nameplate is 1" above center contour to bottom of letters, 7 1/4" from rt edge of lid.
"Hemi" nameplate was on the left side but I don't have those measurements handy, sold that car a couple years ago but will post a photo.
Dash nameplate 5" from A-pillar trim to rt edge of nameplate, 1 1/4" from top of glovebox door to bottom of nameplate.
Dash bird is standing type, 3/8" gap to nameplate, centered heightwise off the nameplate.