I use to mark my radial drag tires tires with a small dab of shoe polish on the tire by the tire stem, once it moved a inch or two I would swap the rims from side to side to move them back Most of them would take a set after swapping sides several times and not move anymore I was running 18+ Lbs. also with no glue or rim screws either, 3450 Lbs. running mid to low 1.40 sixty foot times I had to add rim screws on the bias tires though
This is exactly what I did. I switched to radials and had the same issue with the tires spinning on the rim, well one tire. Cab gave me the same advise and it worked as described.
But these Drag Radials are directional .
If you tire is only moving say 1/2" per run I would not worry about it, your not going to get a better 60' .
