I am building/lowering a 86 w150 chassis for a 2x gasser truck..

it has the stock blocks/u-bolts/shock plates on the rear. same as a w250 as far as the blocks & u-bolts/shock plates go.

I just scratched up a short set for a d100 2x chassis.

I will be removing them next week if you want them. shoot me a PM

I have a set of studs that I had made for the 2 in the diff when I used add a leafs, made them a little longer to compensate for the thick add a leaf. made them from cold roll steel.

it has 2 different thread pitches 1 course 1 fine. IIRC 9/16

that 1 u-bolt is an odd ball size also/driver side is 2 - standard 3" u-bolts


you can get some cut to fit ones in the cheap lowering block kits that part stores have on the shelf for the rear if you have to have them NOW.

I will be ditching the front cad axle on mine and will have the 2 upper u-bolt plates that the front swaybar hooks too and the studs/u-bolts from the d44 or the longer studs if you want them.

the cad axles will be looking for a home also. I wont use any of the locking hubs (manual waren lock outs on it)

ditching the 318/727/208 running gear.

what all will you need to put it back stock?

rear drive shaft?

front d44 studs/u-bolts/plates?

rear u-bolts/blocks?

LMK