its a cut down housing that came with the car.
My problem is I can't mock anything up in car to measure from.
I have the measurements on stock housing width- but we don't know the pinion centerline within a stock housing.
if I had that, I can determine if housing was narrowed wrongly or- wrong axles.
I have another set of Strange axles as well- 35 spline, but again, not sure what stock pinion centerline to housing width is on dusters.
The Strange axles I have are only 1/2 inch studs, my Moser's are 5/8.

Last edited by RustyM; 03/09/18 12:38 PM.