There are lots of good products out there but few that need little work to install. What you want to keep in mind is is the cap ready to install or will it need a ton of work before and once installed. Here is what to look for Is the cap ready to install on the face or do they have to be cut on a cap cutter. Mine don't as they are ready to install. Next are the caps ready to install as far as the register go or do they have to be machine to fit. Mine don't as they are ready to install. Last is the thrust bearing width are they machine to fit or do the caps have to be machines to fit. Mine don't they are ready to go as they are pre-machined to fit.Mine only require a line bore and hone. Otherwise you could be looking at an extra $100 -$200 in machining. Quality pays off in the end but you pay for it up front. I have a special going right now as well free shipping if you mention it in the order. Thanks---Greg

www.bcrproducts.com