Originally Posted By PorkyPig
Originally Posted By Cab_Burge
I've use several sets on customers and my own pump gas street and strip motors with no problems that stop the build or failed after going into service up
Like anything else, make sure you know what you want and need before deciding on buying and selecting any Hi Po parts, cheaper is not always better work
I'm getting ready to build a pump gas 3.91 stroke 440 motor to sell, it will probably end up with a set of the Icon pistons with the reverse dome, D dish, pistons in it to make between 10.0 to 10.5 to compression ratio with a set of aluminum 440 source Stealth heads up

Can you tell me more about the parts you will use in that build? Are you offset grinding a stock crank or buying a new one? What will you use for rods?

I tried to PM you on this, not possible shruggy
Send me a E mail at cabburge@wans.net so I won't tie this thread up more about the details scope


Mr.Cab Racing and winning with Mopars since 1964. (Old F--t, Huh)