Pull LCA forward? - Moparts Forums

Register Log In Moparts Forums Unlawfl's Race & Engine Tech Pull LCA forward?

Print Thread

Re: Pull LCA forward? [Re: JLaSalle] #2419050 12/15/17 03:32 PM 12/15/17 03:32 PM
Joined: Mar 2006 Posts: 9,893 MI, usa dvw master
dvw master Joined: Mar 2006 Posts: 9,893 MI, usa	The method I used was to cut the ends off off the stock rods. Turned them down a touch on the lathe. This allowed the ends to slip fit into 3/4 x.090 moly tubing. Welded it all back up 3/8" shorter than the originals. Doug

Entire Thread
Subject	Posted By	Posted
Pull LCA forward?	JLaSalle	12/15/17 05:57 AM
Re: Pull LCA forward?	Moparteacher	12/15/17 06:27 AM
Re: Pull LCA forward?	JLaSalle	12/15/17 05:02 PM
Re: Pull LCA forward?	Dave Hall	12/15/17 06:55 AM
Re: Pull LCA forward?	JLaSalle	12/15/17 05:19 PM
Re: Pull LCA forward?	dvw	12/15/17 03:43 PM
Re: Pull LCA forward?	JLaSalle	12/15/17 05:22 PM
Re: Pull LCA forward?	SportF	12/15/17 05:24 PM
Re: Pull LCA forward?	dvw	12/15/17 05:54 PM
Re: Pull LCA forward?	Triple Threat	12/15/17 05:59 PM
Re: Pull LCA forward?	krautrock	12/15/17 06:30 PM
Re: Pull LCA forward?	dvw	12/15/17 07:32 PM

Moderated by Al_Alguire, Hotwheelsjr, moparts, not_a_charger, RangerDan440, tboomer

Hop To

Powered by UBB.threads™ PHP Forum Software 7.7.1