I was attempting to degree the cam but it won't rotate enough either way to do that I did run into the cam hitting the rods when I slid it in so I rotated it enough to get it to slide in, I then rotated the crank assembly with all the rods and pistons installed in the block and it didn't hit the cam then Once I set it up to TDC and rotated the cam around to install the timing gears and chain with it align for zero cam advance it hit on the #3/4 and #5/6 rods
Last edited by Cab_Burge; 07/21/1705:21 PM.
Mr.Cab Racing and winning with Mopars since 1964. (Old F--t, Huh)