So I don't have any photos at this time, but should have some this weekend if the weather holds up. I have been slammed at work and also had an injury that slowed me down a bit. My 275's still rub on the drivers side (outside wall of tire) during an occasional left turn. I used a torch to clean off the undercoating so I could try to widen the inner wheel well some on the outside of the tire. I was very careful and used a bottle jack and a torch but every time I removed the bottle jack, the tub just moved right back into its original position. Anybody have any tips on using the bottle jack/torch to "open" up the inner wheel tubs? If you look in the trunk, there is approx 3" of clearance from the inner tub to the quarter panel. If I could get 3/4" more clearance then I could keep the 275's and not have to waste money buying 255's for a swap. Any thoughts?