Originally Posted By Grizzly
This has worked for me on OBD2 and up Rams:

Turn the key on, no-start postion. Slowly push the throttle to wide-open and slowly release back to zero. Do it three times. Shut the key off.

Wait a second or two and fire it back up. Drive.

This procedure resets the Throttle position sensor.

I know yours is drive-by-wire, but this is worth a shot and costs you nothing to try.

If it doesn't work, disconnect the battery as mentioned for 20 minutes. Hook back up and it will go into "re-learn".

Trip to the dealer would be next....... down



JTEC can be reset by undoing the negative cable, then holding the key in the start position for 20 seconds. I've always wondered if that works on the NGC or later stuff