This is the end result after buffing with the Diamond cut and a foam pad. I then followed it up with a hand galze. I painted this car in my garage with a base clear paint system. I have been painting cars since I was 16, so I already had lots of equipment. I did spend about $1k for materials and lots of hours of labor.
The point I am trying to make is with your roll on method, you can get good results! You have to make sure your surface prep is good, and take your time. Getting it thin enough to be able to work it without the bubbles will save you lots of time later during the wet sanding. Once you have a good coat of paint on it then wet sand with fine paper and buff the heck out of it. You WILL get a great shine.
