to make a long story short
i have this dana 60 housing i picked up dirt cheap
with a pile of other parts.
its supposed to of came out of a camaro race car
it has some honked up moved around perches
on it and ladder bar brackets welded to it.
the bom says it is a 69.5 - 72 b body 4.10
with a early 69 date code
end to end it is approx 55 inches long.
the perches on it seem to match up to a ebody perch width comparing it what i have.
the center pin holes on the perches seem larger then stock mopar ones
so i'm going to just cut them off and move them to begin with.

my question is would this rear be feasable to
stuff under a 71 b body?
the 71 8 3/4 rear i have is much a wider housing to begin with and i don't know if it will be a conflict with the housing being short
if i put the perches in the same width as the rear i have?