Sealing a Big Block for a Vacuum Pump

Print Thread

Re: Sealing a Big Block for a Vacuum Pump [Re: 451Guy] #2111308 07/16/16 08:02 PM 07/16/16 08:02 PM
Joined: Dec 2006 Posts: 4,647 aotearoa rebel master
rebel master Joined: Dec 2006 Posts: 4,647 aotearoa	my rear main seal is installed the std way around. i have 5" vac on idle cold with an aluminium block. when my rings were tired my vac was low but on a fresh build its all good.

Entire Thread
Subject	Posted By	Posted
Sealing a Big Block for a Vacuum Pump	451Guy	07/16/16 07:06 PM
Re: Sealing a Big Block for a Vacuum Pump	hustlin hoosier	07/16/16 08:41 PM
Re: Sealing a Big Block for a Vacuum Pump	451Guy	07/16/16 09:31 PM
Re: Sealing a Big Block for a Vacuum Pump	MR_P_BODY	07/16/16 10:00 PM
Re: Sealing a Big Block for a Vacuum Pump	rebel	07/17/16 12:02 AM
Re: Sealing a Big Block for a Vacuum Pump	max_maniac	07/18/16 03:37 AM
Re: Sealing a Big Block for a Vacuum Pump	MR_P_BODY	07/18/16 04:12 AM

Hop To