Got about 30 hours on the intakes went to do the exhaust, and then I seen em.. AIR PUMP PORTS.
So can they be epoxied? Or do I have to braze em shut? Also, just the outside ones, or the inside ones? Thanks.
Drill and tap the holes for a set screw that will sit below the flange surface. It's been a while since I did a set, but you might not have to drill if the hole size is right for tapping. Can't remember if it was 1/4" or 5/16".
Mike Beachel
I didn't write the rules of math nor create the laws of physics, I am just bound by them.