Looks like you got it already. Heads are pretty simple the oil goes from the passenger side oil galley where the lifters are, down to the #4 crank bearing, then upto the #4 cam bearing. The cam directs and limits the amount of oil going to the heads.
Anyhow, the oil goes from the upper part of the cam bearing to the deck, through a hole in the head gasket into the head where it comes out the #4 rocker shaft mount then the oil flows through the hollow rocker shaft to holes drilled in the shaft for each rocker arm.

Small block is simular, but oil comes up the #2 and #4 cam bearings depending on if it is the passenger side or drivers side. Also, the oil hole in the small block heads is not a direct path like a big block, the oil flows from the heads deck surface to the inside area of the head bolt, than from the top of the head bolt passage to the rocker stand. If using head studs the head bolt hole should be enlarged so oil flows arounf the larger diameter head stud (on the small block engines.)