I had a loose lifter bore in my Mega block last winter after 8 seasons of use and had a local shop install a bushing to fix the problem.All the other bores seem to be ok. It seemed to fix the problem(tightened it up) but I noticed that my oil pressure was a little low on the return road(10-15 lbs last year.The car ran good.
I am getting ready to put motor back in for this year and noticed that the lifter bore is loose again!!!There is obvious wear near the bottom of the bronze bushing. I am thinking that it was installed incorrectly.
Where in Central Pennsylvania can I get someone to do this correctly?
Thanks Mike