I installed a new set of MP 456/457 S/S springs
on my Duster and can not adjust the angle of
the pinion DOWN enough.

This is the same 8-3/4 housing/pumpkin that was
in the car w/stock 318 springs when I bought
the car.

I've added 2 sets of 2-degree wedges per side
so 4-degrees tilt and it still is not enough.

I have longer rear shackels that I built that
have 6 inches between bolts.

I'm at a loss as what to do next other than
borrow another set of S/S springs that a buddy
has left over from when he upgraded to Caltracs.

I'm open to opinions and comments.