AAR Cuda - Correct orientation of "Hood Pins"

Print Thread

Re: AAR Cuda - Correct orientation of "Hood Pins" [Re: Transamcuda] #1910080 09/10/15 06:42 PM 09/10/15 06:42 PM
Joined: Jul 2007 Posts: 291 St. Louis I Imrare OP enthusiast
Imrare OP enthusiast I Joined: Jul 2007 Posts: 291 St. Louis	Great pics, thank you very much...mine are oriented from side to side however the car was restored (by someone else) in '09 and I wasn't sure that it was correct. My previous AAR had them front to back but it had been "messed with" as well. I agree with AARCONV that the pins look better in the front to back layout but to change that now would require drilling the rivets and re-orienting my hood pin "plates" (there are slight wear marks where the pins contact the plates and I would want to keep that consistent). When it comes to re-riveting the plates I become a little nervous working with a 45 year old fiberglass hood...Yikes. Thanks again for the photos, Bob Last edited by Imrare; 09/10/15 06:45 PM.

Entire Thread
Subject	Posted By	Posted
AAR Cuda - Correct orientation of "Hood Pins"	Imrare	09/10/15 12:53 AM
Re: AAR Cuda - Correct orientation of "Hood Pins"	6pkaar	09/10/15 02:34 AM
Re: AAR Cuda - Correct orientation of "Hood Pins"	1970_EK2AAR	09/10/15 03:36 AM
Re: AAR Cuda - Correct orientation of "Hood Pins"	Transamcuda	09/10/15 06:11 AM
Re: AAR Cuda - Correct orientation of "Hood Pins"	Transamcuda	09/10/15 06:17 AM
Re: AAR Cuda - Correct orientation of "Hood Pins"	Imrare	09/10/15 10:42 PM
Re: AAR Cuda - Correct orientation of "Hood Pins"	AARCONV	09/10/15 06:51 PM

Hop To