Small Block Header port design and gasket area problem

Print Thread

Re: Small Block Header port design and gasket area problem [Re: mopowergtx] #1874426 07/20/15 04:59 PM 07/20/15 04:59 PM
Joined: Jun 2006 Posts: 3,075 Eastern Ohio mopowergtx OP master
mopowergtx OP master Joined: Jun 2006 Posts: 3,075 Eastern Ohio	Motor out to be able to handle bigger tubes. 494/510 Lunati static tested 9.25 to 1 compression Eddie RPM intake 3.55 gears 2800 stall 2.5" full exhaust on the street.

Entire Thread
Subject	Posted By	Posted
Small Block Header port design and gasket area problem	mopowergtx	07/20/15 04:23 PM
Re: Small Block Header port design and gasket area problem	madscientist	07/20/15 06:50 PM
Re: Small Block Header port design and gasket area problem	mopowergtx	07/20/15 08:59 PM
Re: Small Block Header port design and gasket area problem	Diplomat360	07/21/15 12:13 AM
Re: Small Block Header port design and gasket area problem	mopowergtx	07/21/15 02:51 PM
Re: Small Block Header port design and gasket area problem	Bad340fish	07/21/15 03:10 PM

Hop To