Well all the valiant is moving along slow but steady block is filled and ive started construction of my turbo headers.
Ive been thinking about tubing my car and upgrading the rear from a 8 3/4 to a narrowed dana 60 with 35 spline axles. But the ring and pinion selection for a dana 60 with high gears just isnt out there the highest gear set i can find is 3.54,now my 8 3/4 is setup with a 2.94 suregrip and i was thinking about a even higher gear set like a 2.74 if i keep the 8 3/4.
But i found a good narrowed dana but the gears are way to deep and maybe a member can point me in the right direction ideally id like something around what is offered by mamopar 2.74 to 2.94 or is this not possible in a DANA. Please any and all help is always appreciated
Aaron