Well, what I think I can do is bend the tubing to make me the angle I need to drop down. I have a male AN -12 fitting coming out of the pick up. I was thinking of using 3/4" OD tubing, flaring it and then a sleeve with sleeve nut to attach to the fitting. Once the curve (probably 3-4 inch of hard line) is made I can sleeve and sleeve nut the other end of the hard line and run braided AN -12 hose to the bottom of the pan where there is an AN -12 90 degree. At the pick up, with 45 and 90 degree AN -12 fittings they not only don't fit (not enough room) the angle to the pan is wrong too.