OK found the pic, thought I tossed it for a minute. Basically I went to the local Ace Hardware and bought a nylon bolt large enough to cut the bushing out of it. Dial calipers and a table top lathe were my friends that allowed me to make the bushing. Turned out great, look and fit.

Upper Left - Start Bolt (I bought an extra in case I screwed up the first one)
Bottom Left - Original part
Upper Right - Shank of bolt that was clamped into the lathe, the drop left over
Bottom Right - Fabricated bushing cut from the head of the bolt and a portion of the shank

8427736-PICT0061.JPG (231 downloads)