eliminating ballast resistor wiring for MSD

Print Thread

Re: eliminating ballast resistor wiring for MSD [Re: RMCHRGR] #1446260 06/02/13 04:52 PM 06/02/13 04:52 PM
Joined: Jan 2003 Posts: 26,017 Rio Linda, CA John_Kunkel Too Many Posts
John_Kunkel Too Many Posts Joined: Jan 2003 Posts: 26,017 Rio Linda, CA	Way too complicated. Just jumper the IGN1 (blue) and IGN2 (brown) together at the switch and run a single wire from IGN1 to the MSD red wire. I do this by soldering a piece of brass rod between the two terminals. The INTERNET, the MISinformation superhighway

Entire Thread
Subject	Posted By	Posted
eliminating ballast resistor wiring for MSD	RMCHRGR	06/02/13 04:05 PM
Re: eliminating ballast resistor wiring for MSD	therocks	06/02/13 05:58 PM
Re: eliminating ballast resistor wiring for MSD	RMCHRGR	06/02/13 06:02 PM
Re: eliminating ballast resistor wiring for MSD	topside	06/02/13 08:01 PM
Re: eliminating ballast resistor wiring for MSD	John_Kunkel	06/02/13 08:52 PM

Hop To