so i decided to bring the profile down a bit

http://i1105.photobucket.com/albums/h356/richsplace/58%20dodge%20truck/DSCF1030_zps80b340e2.jpg



i made some sleeves to insert into the pillars to use to guide the roof back into posiion




it was decided to take two inches out of the height. in doing this the roof needed to be sliced through the center, to gain the proper width required to lower her back into position.







<img src="http://i1105.photobucket.com/albums/h356/richsplace/58%20dodge
%20truck/DSCF1113_zps007fe545.jpg">