Quote:

How can the seam that attaches the cap to the 1/4 panel be welded or tacked. I will supply a few pics , any ideas for those who have done it.






I mocked my rear valance and end caps up on the car where I wanted them, just a few tacks to hold all 3 pcs together, then removed them from the car as 1 piece and welded the end caps from the backside to the valance, then drilled a few holes on the rear qtr tabs that the end caps mate to, then plug welded the end caps to the flange from under the trunk extensions, and welded the rear valance to the car as 1 assembly, this way you have no weld "dressing" to do on the end caps, other than a small application of seam sealer embedded in the seams of the end caps to prevent rust, but not to much that you lose the end caps seam definition

Mike

7372187-melon.jpg (97 downloads)