Quote:

---

SSWWWEEEETT!!! that is looking nice!

kool how a A-body 8 3/4 will just bolt right into the trucks.

are you going down low with it? fliping the shackle? how long did the drive shaft wind up being? bed tubbed yet?

I cant tell by pics but hope the shocks have room with the pipes,they get spred out a good ways.

I had to clearance the cross brace for a fat airshock,stock shocks fits ok if pipes are not in the way.

I just drove mine for the first time with all 3 gears,went 150 miles so far,I think you will like it. my face cheeks hurt from the whole way.

---

Scratch, I'm only doing the axle flip for now and lowering the front the same by trimming the coils a little, the bed is tubbed with S&W steel tubs and honestly, the drive shaft has me a little nervous...when I attached it to the rear end it sure did slide a long way up into the trans... , gotta do some more checking on that. The shocks look like they are going to clear the pipe, however, when I get the new engine in I may remove them anyway, not sure yet, may go with turndowns and bigger pipes.